Enantioseparation of amino acid derivatives on an immobilized network polymer derived from L-tartaric acid

Seven structurally related amino acid derivatives were successfully enantioseparated by HPLC with a commercially available column containing a chiral immobilized network polymer derived from L-tartaric acid. The experiments were carried out under normal-phase conditions. All the solutes could be baseline separated using n-hexane/2-propanol (95/5) as eluent at a flow rate of 1 ml/min at 25 degrees C, with reasonable retention time (<12 min). The effects of the polar alcohol modifier (type and content) in the mobile phase and the column temperature on the enantioseparation were studied. Apparent thermodynamic parameters were also calculated from the plots of ln alpha or ln k' versus 1/T. Some mechanistic aspects of chiral recognition were discussed with respect to the structures of the solutes. It was found that the enantioseparations are all enthalpy driven, and the N-acyl groups of the solutes have significant influence on the chiral recognition.     

水／AOT／正庚烷微乳体系中磺酸根水化作用的FT—IR研究

运用傅立叶变换红外光谱（FT－IR）对水／琥珀酸（乙基已基）磺酸钠（AOT）／正庚烷微乳体系中磺酸根的水化作用进行了研究．由于微乳体系中水分子与表面活性剂分子的相互作用，S＝O对称伸缩振动的红外吸收峰向低频方向移动．体系中的加水量W0（水与AOT的摩尔比）由0.5增大至25时，磺酸根对称伸缩振动的红外吸收峰由1051．39cm－1向低频移动至1046．15cm－1．同时，由于Na 的不对称作用，AOT分子中磺酸根反对称伸缩振动分裂成两个吸收峰，分别位于正215cm-1及1245cm－1附近，两个劈裂峰的距离及各自的峰面积均随体系中加水量的变化而变化，应用二阶导数、傅立叶退卷积及曲线拟会等分辨率增强技术可更清楚地反映出这个二重峰的变化情况．固体AOT分子中碳酸根反对称伸缩振动分裂的两个峰之间频率的差值约为42cm－1，形成微乳液以后，这两个峰的差值变小，W0为20时，这两个峰频率的差值逐渐减小到29cm-1，这些变化与磺酸根的水化程度直接相关     

凝胶渗透色谱法测定聚丙烯腈共聚物分子量中宽分布校正法的应用

应用宽分布校正法对凝胶渗透色谱(GPC)进行了校正，将校正曲线用于聚丙烯腈(PAN)共聚物分子量的计算。对扣除色谱峰扩展效应前后的测试结果与乌氏粘度法测得的数据进行比较。结果表明，应用宽分布校正法时，必须扣除色谱峰扩展效应，才能得到较为准确的测试结果。     

A resonance Raman study of octopus bathorhodopsin with deuterium labeled retinal chromophores.

The resonance Raman spectrum of octopus bathorhodopsin in the fingerprint region and in the ethylenic-Schiff base region have been obtained at 80 K using the "pump-probe" technique as have its deuterated chromophore analogues at the C7D; C8D; C8,C7D2; C10D; C11D; C11, C12D2; C14D; C15D; C14, C15D2; and N16D positions. While these data are not sufficient to make definitive band assignments, many tentative assignments can be made. Because of the close spectral similarity between the octopus bathorhodopsin spectrum and that of bovine bathorhodopsin, we conclude that the essential configuration of octopus bathorhodopsin's chromophore is all-trans like. The data suggest that the Schiff base, C = N, configuration is trans (anti). The observed conformationally sensitive fingerprint bands show pronounced isotope shifts upon chromophore deuteration. The size of the shifts differ, in certain cases, from those found for bovine bathorhodopsin. Thus, the internal mode composition of the fingerprint bands differs somewhat from bovine bathorhodopsin, suggesting a somewhat different in situ chromophore conformation. An analysis of the NH bend frequency, the Schiff base C = N stretch frequency, and its shift upon Schiff base deuteration suggests that the hydrogen bonding between the protonated Schiff base with its protein binding pocket is weaker in octopus bathorhodopsin than in bovine bathorhodopsin but stronger than that found in bacteriorhodopsin's bR568 pigment.     

Development, validation and transfer of a hydrophilic interaction liquid chromatography/tandem mass spectrometric method for the analysis of the tobacco-specific nitrosamine metabolite NNAL in human plasma at low picogram per milliliter concentrations

A highly sensitive bioanalytical method based on a simple liquid/liquid extraction and hydrophilic interaction liquid chromatography with tandem mass spectrometry (HILIC/MS/MS) analysis has been developed, validated and transferred for the determination of 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanol (NNAL), a tobacco-specific nitrosamine metabolite. Deuterated NNAL (NNAL-d(4)) was synthesized and used as the internal standard. This method can be used for the analysis of free and total NNAL (free NNAL plus NNAL-gluc) in K(3)-EDTA human plasma. Free NNAL and NNAL-d(4) are extracted from human plasma by liquid/liquid extraction. To analyze for total NNAL and the internal standard, a separate aliquot of the K(3)-EDTA human plasma is treated with beta-glucuronidase to deconjugate the NNAL-gluc; the total NNAL and internal standard are then extracted using liquid/liquid extraction. After drying down under nitrogen, the residue is reconstituted with acetonitrile and analyzed using positive ion electrospray and HILIC/MS/MS at a flow rate of 1.0 mL/min. The chromatographic run time is 1.0 min per injection, with retention time for both NNAL and NNAL-d(4) of 0.75 min with a capacity factor (k') of 2. The standard curve range for this assay is from 5.00-1000 pg/mL for both free and total NNAL, using a total plasma sample volume of 1.0 mL. The interday precision and accuracy of the quality control (QC) samples demonstrated <7.6% relative standard deviation (RSD) and <3.3% relative error (RE) for free NNAL. For total NNAL, the interday precision and accuracy of the QC samples demonstrated <11.7% RSD and <2.8% RE. Optimization of enzyme hydrolysis of NNAL-gluc is discussed in detail. The overall recoveries for free and total NNAL and IS were 68.2 and 71.5% (free) and 70.7 and 65.5% (total). No adverse matrix effects were noticed for this assay.     

KINETICS OF SUSPENDED EMULSION POLYMERIZATION OF METHYL METHACRYLATE

The kinetics of suspended emulsion polymerization of methyl methacrylate (MMA), in which water acted as the dispersed phase and the mixture of MMA and cyclohexane as the continuous phase, was investigated. It showed that the initial polymerization rate (Rp0) and steady-state polymerization rate (Rp) were proportional to the mass ratio between water and oil phase, and increased as the polymerization temperature, the potassium persulphate concentration ([I]) and the Tween20 emulsifier concentration ([S]) increased. The relationships between the polymerization rate and [I] and [S] were obtained as follows: Rp0 ∝ [I]0.73[S]0.32 and Rp ∝ [I]0.71[S]0.23. The above exponents were close to those obtained from normal MMA emulsion polymerization. It also showed that the average molecular weight of the resulting poly(methyl methacrylate) decreased as the polymerization temperature, [I] and [S] increased. Thus, MMA suspended emulsion polymerization could be considered as a combination of many miniature emulsion polymerizations proceeding in water drops and obeyed the classical kinetics of MMA emulsion polymerization.     

Effect of surface condition on liquid crystal photoalignment by light-induced azo dye adsorption phenomena

The effect of surface condition on the photoalignment of light-induced methyl red (MR) adsorption phenomena on various substrates based on azo dye-doped liquid crystals is investigated. The results show that the polar surface energy determines the initiation of MR adsorption phenomena. The surface polarity energy of different substrates, which are modulated by oxygen plasma treatment (OPT), is further examined using the sessile drop method. The results also indicate that the uniformity and efficiency of MR adsorption can be enhanced by OPT. Light intensity influences the MR adsorption rate. The uniformity of MR adsorption onto various substrates is analysed via polarised optical microscopy.     

Effect of Arylmethylene Substitutions on Molecular Structure,Optoelectronic Properties and Photovoltaic Performance of Dithienocyclopentafluorene-Based Small-Molecule Acceptors

Two dithienocyclopentafluorene-based small-molecule acceptors (SMAs) were developed that feature methylene-functionalized conjugated side chains, to study the effect of arylmethylene substitution and its number on structure, optoelectronic properties and device performance. Results showed that two SMAs have better absorption properties and planarity, lower bandgaps and higher LUMOs compared with the control SMA without conjugated side chains. The synthesized SMAs were tested in polymer solar cells for examples of their applicability. This work argues that the introduction of methylene-functionalized conjugated side chains has great potential in tuning molecular structure, optoelectronic properties, device physics and photovoltaic performance of SMAs.     

Multiresponsive supramolecular gels constructed by orthogonal metal–ligand coordination and hydrogen bonding

Macromonomers bearing tridentate 2,6-bis(1,2,3-trizol-4-yl)pyridine (BTP) ligand unit synthesized via CuAAC “click” chemistry in the middle of the chain and two ureidopyrimidinone (UPy) motifs on the ends linked to the central BTP unit via PEGs of various lengths were synthesized and used for the study of gelation both with and without the presence of Eu(III) ions. Various interesting gelation behaviors were found. Gels exhibited various multi-responsive properties, including photoluminescence, mechanoresponsive properties, self-healing abilities, thermorepsonsive properties and chemoresponsive properties. The different gelation abilities and multi-responsive properties for different systems were shown to be resulted from difference in PEG linker lengths and the introduction of orthogonal metal–ligand coordination and hydrogen bonding interactions. The selective responsiveness to different chemicals would allow the development of modular sensory systems that utilize a combination of orthogonal supramolecular interactions.     

Aptamer-based fluorometric determination of norovirus using a paper-based microfluidic device

Microchimica Acta - The authors describe a rapid and highly sensitive point-of-care device for rapid determination of noroviruses, a leading cause of acute gastroenteritis. The assay is based on...